Home > Control Relay Module >

5V 1 Channel Relay Module For PIC AVR DSP ARM power supply module

Product Categories

Shenzhen Creatall Electronics Co., Ltd.

Trust Seal

Verified Supplier

Credit Check

Supplier Assessment

Contact Now

Add to Cart

The relay coil drive voltage is 5V, and the input control level can also be within 5V.
Output drive capacity: 250VAC-10A, 125VAC-10A, 30VDC-10A, 28V DC-10A.
Easy to use, each output group has a simple 3-wire structure, and 6 output terminals are reserved.
The input is directly connected to the MCU IO port or digital circuit, and the input high-level relay The device is closed, and the input low level relay is released.
Working voltage 5V, pull-in current about 70mA per circuit, with relay status indication light.
Full chip components. Reasonable drive circuit design, using 8050 transistor to drive the relay Electrical action.
There are fixed screw holes for easy installation,
module size: 25.8*33.4*16.7mm. Test Instruction The input and output of the module are electrically insulated.
After the correct voltage is supplied, you only need to Connecting a high level (such as a short circuit with VCC) to the input pin can make the relay pull in,If not connected or connected to low level (such as short-circuit with GND), the relay will not operate.

Product Tags:

5V 1 Channel Relay Module

Inquiry Cart 0

Send your message to this supplier


*From:	Your email address is incorrect!
*To:	Shenzhen Creatall Electronics Co., Ltd.
*Subject:	Subject is empty!
*Message:	For the best results, we recommend including the following details: -Self introduction -Required specifications -Inquire about price/MOQ Characters Remaining: (0/3000) Please enter 20 to 3000 characters to contact this supplier!

Explore more Control Relay Module products from this supplier

Find Similar Products By Category:

Electrical Equipment & Supplies

Hot Searches: